Water Damage Restoration – What Is It? It is the process of repairing a house or property to its pre loss condition. Damage to the property could be due to an overflow, flood or any other water damage and mold event. The water damage restoration process involves several key procedures like loss assessment, categorization based on the water contamination levels, decontaminating and drying the structure, monitoring of the process and completion of the process. There are 2 large certifying bodies, namely the IICRC (Institute of Inspection, Cleaning and Restoration Certification) and also the RIA (Restoration Industry Association) that recommends standards for water damage and mold restoration. The S500 damage because of water guide is the benchmark tool which is used by companies focusing on restoration of water damage.
Loss Assessment and Categorization – Loss evaluation is the foremost and the most important part of water damage restoration. The assessment needs to be correct in order that a suitable response can be taken. In restorating the harm brought on by water, technicians as well as the insurance companies must work together and know what is damaged and how to make restoring the harm. Identifying the origin from the damage, documentation of damage, and accurate estimates are mandatory to get a proper water damage and mold restoration. Categorization relies on the contamination levels of the water source. The categories are the following
Category 1 – This really is water from clean sources like pipes, sinks and toilets without faeces or urine.
Category 2 – This is water which includes some contaminants like water from a dishwasher, washer or toilet with urine.
Category 3 – This really is water which is highly unsanitary and is capable of causing illness or death if ingested. Sewage water, water from toilet with faeces, standing water with microbial growth and floodwater are a few examples.
Decontamination and Drying – After the evaluation is complete, the whole process of drying and decontaminating begins in the site. Based on the extent of damage, damage caused because of water can be classified into 4 types. Class 1 Damage- When loss is fixed to your small area and fewer water has been absorbed by materials. This results in slow evaporation rate. Class 2 Damage – When the damage is to the whole room and carpet area. Class 3 Damage – If the entire area is saturated with water and sophistication 4 Damage – when there are many deep saturation pockets. Decontamination and drying is really a key stage in Water damage and mold restoration and equipments like blowers, dehumidifiers, scrubbers and subfloor drying equipments must be used. Decontamination must be done if contamination has been detected in the community. Decontamination may be performed for the entire area or perhaps in specific pockets where contamination continues to be detected.
Monitoring and Completion – Monitoring the restoration procedure of damage caused due to damage is critical to obtain the desired results. One must be proactive throughout the monitoring process. Checking if the drying devices are setup properly, assessing in the event the personnel involved are qualified for the task and checking if the equipments will be in working order inwtsy all portion of the monitoring process. Necessary steps are to be taken if something wrong is spotted through the monitoring process. The whole procedure for water damage and mold restoration would be considered complete only once humidity, temperature as well as the moisture content is just as per industry standards. Upon finishing of water damage restoration process, the drying equipment can be removed.